Carrier worn or broken?Find the replacement that fits.

Inner dimensions at least equal

Inner height and inner width are at least what you measured (1 mm measuring margin), so your cables keep fitting. At most 50% larger (minimum 10 mm), otherwise the carrier no longer fits in the same place.

Same or slightly wider bend

The bending radius is no tighter than now (2 mm tolerance), because your cables were chosen for that bend. At most 15% larger (at least 10 mm), because a larger bend makes the carrier taller.

Travel length, installation and type

Your travel length falls within what the type can handle self-supporting or gliding. Hanging or standing only for types that may run vertically. Material and open or closed follow your choice.

Fits in the same space

Enter your outer height and outer width, and the replacement will not be larger than your current carrier (1 mm measuring margin).

Match in percent

The closer the height, width, radius, pitch and outer dimensions are to your current carrier, the higher the match. Only what you entered counts. A different pitch does not rule it out, but costs points: the length in links and the end mounting then differ.